Pellet scale

[MrChipShoulder]

Hi All,

I have a set called 'On Balance 150g', I'm not overly happy with it as it keeps changing it's mind. One minute it says 8.4g then weight it again and says it's 8g, and so on !!!!

Can anybody recommend a reliable pellet scale and where to buy?

Thanks.

[angrybear]

I'm guessing you mean 8.4gn rather than 8.4g

It's no different to you standing on a scale - move a bit & your weight will "change", move the pellet a bit & the force pressing on the pad under the tray will change.
Try marking a 5mm circle dead centre of the tray & always put the pellet on the mark.
In practical terms I doubt 1 or 2 10ths of a gn will make any appreciable difference, unless you shoot to international level.

[Rickenbacker]

I take it you mean gr rather than gn

https://www.britannica.com/science/grain-unit-of-weight

[PhatMan]

Sunbeam,

In general, for the 'less-expensive' end, scales that weigh to 20 or 50 grams are a bit better in terms of resolution, than those that weigh to 200 grams

Even the 20 gram scales are not really good enough for single 0.177" pellets, or to check pellet to pellet variations.

They are however fine for getting an estimate of average pellet weights - weigh 50 or 100 pellets, then divide the found weight by 50 or 100.

Have a peek on Amazon for 20 gram 'jewellery' scales - there are a number (mostly the same scale).

Have fun & a good weekend

Best regards

Russ

[YorkshireDave]

This might not be the problem you have, but it's worth mentioning. Make sure your cellphone (and anything else which transmits eg wifi, bluetooth) is well away from the scales. A few years ago I was weighing titanium fasteners for a project and I noticed that the scales often read wrong when there was a cellphone within 8-10' of them. Not far enough wrong to be an obvious rogue reading but far enough wrong to screw up the results. Tried 4 sets of scales, got exactly the same type of errors on everything from a £25 pocket scale to a £1500 pharmacist's lab balance, the only difference was that the pharmacist's balance needed the phone within about 2-3' before the problem started.

[Murphy]

This might not be the problem you have, but it's worth mentioning. Make sure your cellphone (and anything else which transmits eg wifi, bluetooth) is well away from the scales. A few years ago I was weighing titanium fasteners for a project and I noticed that the scales often read wrong when there was a cellphone within 8-10' of them. Not far enough wrong to be an obvious rogue reading but far enough wrong to screw up the results. Tried 4 sets of scales, got exactly the same type of errors on everything from a £25 pocket scale to a £1500 pharmacist's lab balance, the only difference was that the pharmacist's balance needed the phone within about 2-3' before the problem started.

Do you have a reason for this??

Because that explains when I was using my scales downstairs they was being funny when I used my phone for the calculator.

But upstairs I use a normal calculator and they are fine.