Lee Delux Quick trim

[blueheckle]

Ah the trimmer isn’t the old one it’s the one that fits 5he top of the press?

I’m surprised you have a die that’s out of spec but Lee have a good reputation for replacing stuff

Sounds like you are sorted

Lol no the die I have is one of the new spec ones , I gave up on Lee as it was just question after question lol

[Parabuteo]

Lol no the die I have is one of the new spec ones , I gave up on Lee as it was just question after question lol

As you would expect bud, you are suggesting their kit is duff. If that is the case it may be a product fault they may need to flag up.

[Graham2]

As you would expect bud, you are suggesting their kit is duff. If that is the case it may be a product fault they may need to flag up.

I've trimmed hundreds of cases with one of these and have not had a problem, it's a really neat system.

The case is held in a shell holder in the press in the usual way, so should be presented to the rotary cutter correctly each time and a few turns of the handle soon trim off any excess.

[blueheckle]

I've trimmed hundreds of cases with one of these and have not had a problem, it's a really neat system.

The case is held in a shell holder in the press in the usual way, so should be presented to the rotary cutter correctly each time and a few turns of the handle soon trim off any excess.

If you put a trimmed case in your calipers and turn it do you get the same measurement all round or does it vary thanks

[Graham2]

Same all round the case mouth. This is obviously not the case for you but I really can't work out why.

Very odd!

[thesmi]

I have one of these and is really handy tool very confused how it could go out of square. But what I'd do is trim then mark case with pen and rotate 90degress and see what happens because in theory if out of square it would then trim the other side

[blueheckle]

I have one of these and is really handy tool very confused how it could go out of square. But what I'd do is trim then mark case with pen and rotate 90degress and see what happens because in theory if out of square it would then trim the other side

I had a thought last night when I took the chamfer tools out the two outer ones were together and the inner chamfer was next can one of you guys check if this is the correct alignment, I will try the marker simple but good idea tks

[Parabuteo]

I've trimmed hundreds of cases with one of these and have not had a problem, it's a really neat system.

The case is held in a shell holder in the press in the usual way, so should be presented to the rotary cutter correctly each time and a few turns of the handle soon trim off any excess.

I know, I was trying to suggest why Lee would ask a lot of questions