Results 1 to 4 of 4

Thread: a challenging reseal

  1. 26-08-2018, 08:49 PM #1
    --ped--
    --ped-- is offline Registered User
    Join Date
    Dec 2016
    Location
    leeds
    Posts
    2,067

    a challenging reseal

    had to make a set of new fixtures tonight to remove a valve nut from a soldered Benjamin
    this nut was the tightest one I've come across and was also loctited by the look of it coupled with the fact it was in immaculate condition made it a difficult process
    I made up two nylon 66 vice clamps that will spread the load and not mark the finish probably never use these again as they're only fit the transitional models but I think I'll make a set for c series and the Bengy 312/7 and 342/7
    https://i.imgur.com/U427ac3.jpg
    https://i.imgur.com/cZiLUfR.jpg
    https://i.imgur.com/MZXanCW.jpg
    Reply With Quote Reply With Quote
  2. 26-08-2018, 08:57 PM #2
    deejayuu
    deejayuu is online now Registered User
    Join Date
    Jun 2012
    Location
    North Wales
    Posts
    3,170
    Good result.
    Reply With Quote Reply With Quote
  3. 27-08-2018, 06:05 AM #3
    AllanM
    AllanM is offline Registered User
    Join Date
    Sep 2011
    Location
    Scarborough
    Posts
    464
    I remember you saying you didn't like to be beaten!
    That really is fantastic work.
    Reply With Quote Reply With Quote
  4. 27-08-2018, 08:08 AM #4
    mdunn
    mdunn is offline Registered User
    Join Date
    Feb 2009
    Location
    Leeds
    Posts
    2,419
    job well done, atb mick
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules