Raining today, so didn't get to finish the shed insulation panels, so made the pellet catchers instead.
I welded them up from some scrap 3mm plate steel I had.
they hold 17cm targets that are to be held in place by the whizzer hanger.
They will bolt onto an angled bracket so the rear plate is angled, but the face is vertical.
I have gone for a deep tray in the bottom with a full length 6mm slot so the pellets can fall out the bottom into a collection trough.
This means the catchers will never fill up, they won't need to be removed and the dead pellets can't bounce up and damage the target from behind!!
The front faces are 4mm thick and are angled so any stray pellet will be deflected sideways.
https://ibb.co/czXi69
https://ibb.co/d3o1tp
https://ibb.co/hU5szU