Crossman M4

[Ragle Jnr]

Have bought one of these but struggling to find a suitable scope/mount combination. Picatinny but need about 40mm height. Anyone know where I can get one? TIA David

[RichardH]

Try these

https://www.uttings.co.uk/p121333-ha.../#.W5wgMFrTWhA

[Ragle Jnr]

Try these

https://www.uttings.co.uk/p121333-ha.../#.W5wgMFrTWhA

Wow that was quick Richard, but need min 40 mm to clear foresight ramp. David

[angrybear]

Picantiny to dovetail raisers, then high mounts on top.

But if you're using a scope just remove the fore-sight

[RichardH]

Wow that was quick Richard, but need min 40 mm to clear foresight ramp. David

Height: 53mm / 2.1"

Looks like just the job?

[Ragle Jnr]

Picantiny to dovetail raisers, then high mounts on top.

But if you're using a scope just remove the fore-sight

Thanks angry bear, I hadn't thought of either solution, will see if front sight can be drifted off tomorrow!

[Geezer]

Thanks angry bear, I hadn't thought of either solution, will see if front sight can be drifted off tomorrow!

If this is the M4-177, I think the front sight removes via a large slotted screw on the left.

[Ragle Jnr]

Well it says M4 on it and it is 0.177cal. But it's a single shot break barrel, not a pump action. The foresight appears to be held on by two pins, and the flash hider by a grub screw. I have found a carry handle rear sight, which may take an AR picatinny adaptor. Still hoping to find a picatinny riser though! David

[Geezer]

Well it says M4 on it and it is 0.177cal. But it's a single shot break barrel, not a pump action. The foresight appears to be held on by two pins, and the flash hider by a grub screw. I have found a carry handle rear sight, which may take an AR picatinny adaptor. Still hoping to find a picatinny riser though! David

I was thinking of the little multi-pump.