-
PP700SA Target sight
Has anyone found a target sight that can fit into the dovetail groove when the original rear sight is removed? I had hoped SMK would make one, but it seems not.
-
-
Crumbs, that’s cheep as chips. Wonder what you do for the front sights on the standard PP700. It doesn’t seem to show and not sure if it’s mentioned as my translation seems a bit vague.
I was after one to fit the dove tail on the SA pistol from where it’s windage sight is removed. Something similar to what umarex used to do for the co2 range would be epic. I have tried this and many others but so far no match.
-
The translations says "you need to knock one(front sight) up yourself".
-
I used a long bolt can’t remember m2 or m2.5 or thinner? Ground it down to a sharp point.
To change POI you have to loosen up the barrel and when spun clockwise it rotates the barrel and the sleeve at the same time so it gives you both vertical and horizontal adjustment. Gives more adjustment than tweaking the rear sight in my experience.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules