BSA Goldstar under lever modification.

[Steve Zodiac]

I'm sure I read somewhere that you can modify the under lever Goldstar in to accepting the modern BSA self indexing magazines by doing away with the little indexing pin that pops up on the cocking cycle to index the original magazine.

Most rifles originally came with a single mag that seemingly was very dependant on the type of user / abuser and either worked with care, or failed if you were the John Wayne Winchester type.


Question.

Is it a worthwhile modification to remove the pin and allow use of several spare magazines with greater reliability ? How difficult is it to remove said pin mechanism which I believe ( info is thin on the subject ) is attached in someway to the cocking lever ?

Are there spares available as I wouldn't like to render the rifle irreversible should I want to switch back to original.

Any thoughts or experience on the subject please ?

[Thegreg]

This has been covered before but not with any real definitive answer as you say.

I own an old Goldstar and have also asked the question about magazine compatibility.

I believe you can modify a new-style magazine to work in the old Goldstar.

I too have read about removing the indexing pin from the underlever but would never consider modifying the rifle to suit the magazine, would much rather modify the magazine to suit the rifle!

Cheers
Greg

[Micky Spillane]

I'd go along with the above, having owned a Goldstar I never really had a problem with magazine indexing once I understood the principle of the operation bearing in mind the mag was built as a development stage to the Super ten. I miss my old Goldstar but it went to a good home.

[Steve Zodiac]

This has been covered before but not with any real definitive answer as you say.

I own an old Goldstar and have also asked the question about magazine compatibility.

I believe you can modify a new-style magazine to work in the old Goldstar.

I too have read about removing the indexing pin from the underlever but would never consider modifying the rifle to suit the magazine, would much rather modify the magazine to suit the rifle!

Cheers
Greg

I don't mind modifying, but the key is that it must be possible to return the gun to original, if its a reasonably straight forward job to remove the pin indexer ( can I call it that ) obtain a spare incase of the inevitable ping into bits then I'd be happy to do it.

It keeps the one remaining original Mag in good order, and means I don't have to cut/ file or modify any newly purchased mags.

It really needs someone who either done the modification or maybe replaced the original pin because of failure or damage etc.

I looked on the simple guide to stripping but couldn't see any mention of the Goldstar.

I think there's a hole under the chamber that can be viewed if the rifle is upside down with the cocking arm in the pulled back position . I'll have a look tmrw try and work it out.

[Steve Zodiac]

Nobody ever stripped down a Goldstar or know of their complexities ?

[T 20]

Nobody ever stripped down a Goldstar or know of their complexities ?

Rancidtom seems to be the man to ask about this.

[grezoor]

Perfect timing, I have just acquired three very nice original .177 goldstars but no mags, I have done some research on previous threads but there seems to be some confusion (to me anyway) whether or not the new type mags fit and I can say that having bought a new blue .177 mag yesterday that they do not
Looking forward to see where this thread goes regarding altering / adapting the mag, like the other guys I would rather mod the mag rather than the rifle