Two-pin tool for Rapid Reg

[Jonathan]

Guys, would anyone have the dimensions for the two-pin tool for removing the screw in a Mk2 reg?

I need pin diameter, pitch, clearance hole diameter and outside diameter. Any help greatly appreciated.

Jonathan.

[kevG]

11.2 diameter.gives you a bit of waddle room.4mm centre bore.to a depth of at least 6mm.pins 2mm diameter. 8mm centre to centre
problem is push pin disc blind holes can differ slightly .
kevG

[angrybear]

Chap sells the tool on the bay of e, mk2 or MFR.

[Jonathan]

11.2 diameter.gives you a bit of waddle room.4mm centre bore.to a depth of at least 6mm.pins 2mm diameter. 8mm centre to centre
problem is push pin disc blind holes can differ slightly .
kevG

Thanks Kev. That is really useful. I’ll get one knocked up in the morning. 👍

Jonathan.

[smudger1234]

On the subject of rapid regs does anyone know the size of the circlip (and ideally where to get them) on a MK1 reg?
I just received a rifle and someone has replaced the circlip with an o ring and a lot of superglue!

[kevG]

they are not mk1 regs.just the early version that you got on the early mk2..got some some were will have a look.
kevG

[kevG]

if it's on a mk1 it may have had action reported to take reg.
kevG

[smudger1234]

if it's on a mk1 it may have had action reported to take reg.
kevG

My mistake it looks like an earlier MK2 rifle. I contacted the mate I got it from and he says it was 'repaired' about 5 years ago.
Everything about the rifles seems completely pristine just this strange modification.