What have I done
Sold my Single shot Ultra and bought a brand spanking new Ultra XL.
The single shot went as I wanted a multi shot rifle. That thing was accurate as hell and so well made.
The XL is very NOT.
Plastic trigger blade that you have to keep pulling....and pulling.....and pulling. Miles of creep but I might be able to sort that?
Plastic (although silent) safety catch.
Glue reside on butt pad which has stained it and I had to scrape the dried excess off with my nail. It might be lacquer rather than glue? Not sure.
The brass ring at the filler cap join is corroded/discoloured with black marks
The magazine itself seems OK and loading is easy but I've seen you tube clips where they just slip in and are pulled home by the magnet. Not mine, have to push it home firmly and tricky to line up.
The thread on the filler probe was poor.
Took a fair amount of cleaning the barrel to get it to group with JSBs which, in fairness, it did in the end but the single poorly photocopied sheet of paper that is supposed to be the manual said they are accuracy tested at the factory! I guess so if you are aiming at bin lids at 5 yards.
Worst of all though, It came with 110 bar fill. I topped it up with my Hills pump to 230 bar. Fired off a few magazines and down to 120 bar (according to the wonkily tilted filler gauge - come on guys, at least make it level) and it wont fill. Air leaks out of the probe whilst it's pushed home.
I've tried cocking the gun, wiggling the probe, my old probe, pushing the probe in and out etc etc. Not filling.
I've e-mailed the company I bought it off and awaiting a reply tomorrow hopefully.
Not impressed. BSA, in my opinion, on this rifle (Which don't forget retails around 450-500) have gone cheap and it shows.