On the few i have done i used Dem bart tools & they are very good, First one was a 1970's BSA mercury that had a panel each side on the foreend & a panel each side of the grip, I would know it instantly if i saw it again as i got one line on the left? side of the fore end a bit wonky & to me it stood out a mile! I have done a few others including a mk3 webley stock, this was done with panels with fleur de lys top & bottom & a 5mm wide clean ribbon through the middle of the panel, no borders either. Came out pretty good if i say so myself but its still not quite finished 20 years on, Must get round to it!