The tap has worn and is traveling too far to the right,After removing the ball but leaving in the spring (which is just touching the cover plate)she’s shooting every shot,if I overtighten the screw on the tap side it pulls back the tap body and chops them again,if I make a shim that sits on the end of the tap so it lets the screw Not tighten down the tap body but leaves it tight it should leave the body in position and not pull the tap body over.
Otherwise I would be looking at a new tap body for£55 which is never going to happen lol.
Plus I would have to bed in the tap body again and for what I’m going to be using it for it’s not worth it (spinning cans).