Just punch it mate
Is this a drill the head off and pin punch out? or just pin punch out?
Cheers.
Roy.
If it moves.....shoot it!..If it don't move.....shoot it in case it tries to!!!
Light travels faster than sound....this is why I appear bright until you hear me speak!!!
Just punch it mate
LOOKING FOR A BSA ULTRA IN .177 and .25
Punch it out then get a qr cocking pin to replace it, i now have these on all my break barrels.
I get mine off of Paul Short
Hello to All,
IIRC, Mr. Pope used to recommend using a centre-punch first to get the pin started (from right hand side), then a pin-punch to finish.
Have fun & a good weekend
Best regards
Russ
just punch it out,mine took some shifting
Ta folks........is now out!
Cheers.
Roy.
If it moves.....shoot it!..If it don't move.....shoot it in case it tries to!!!
Light travels faster than sound....this is why I appear bright until you hear me speak!!!
That's very interesting Russ, I'd never considered there was a correct direction to drift the pin out. That implies HW make them , or at least install them, with one end weaker than the other. Have others found the same?
All best
Jim
ps is the RH looking from stock to muzzle?
Last edited by Dagwood; 16-02-2019 at 07:47 AM.