Vintage Scopes

[bill57]

If you can dismantle the scope, then I don't think fixing the reticle would be too difficult. I have seen very fine wire advertised for crosshair repair on the auction site, so a basic crosshair should be achievable. I wouldn't worry about nitrogen loss, I suspect it will be long gone from these scopes.

[harvey_s]

If you can dismantle the scope, then I don't think fixing the reticle would be too difficult. I have seen very fine wire advertised for crosshair repair on the auction site, so a basic crosshair should be achievable. I wouldn't worry about nitrogen loss, I suspect it will be long gone from these scopes.

I have also seen this .005" tungsten wire advertised and articles relating to repairing finderscopes on telescopes, so I wondered if anyone had tried it...I assume the dismantling without damage is the tough bit!

[averageplinker]

I have a scrap Kassnar Vista scope somewhere (broken ret). Maybe I will try taking it apart and if that goes well see if we can repair the reticle and report my findings.

[harvey_s]

I have a scrap Kassnar Vista scope somewhere (broken ret). Maybe I will try taking it apart and if that goes well see if we can repair the reticle and report my findings.

That would be interesting...thank you.

[bill57]

Here's a Sornet 6x42. All steel, nice plum colour, German 3 post reticle. It has only elevation adjustment, so the windage is done using the screws visible under the rear mount. The rear mount is also shimmed so the reticle is nicely centred.

[averageplinker]

Never mind the scope that sidelever rifle is bloody gorgeous!!!

[Geezer]

Never mind the scope that sidelever rifle is bloody gorgeous!!!

Agree!

Bill - what is that? It’s lovely.

[averageplinker]

That would be interesting...thank you.

Might even try this afternoon whilst cheering on Ireland (hoping they do England a favour!)

[averageplinker]

Ok, halftime in the rugby so I will update my findings on the scope so far.....

It is a Kassnar Vistascope 3-9x40, made in Korea. The reticle is snapped and the mag ring is notchy and stiff at the higher end, say x7-9. One of the turret caps is dented and scratched. Therefore I am guessing it has been dropped to break the ret rather than being a victim of Springer recoil.


The ret is surprisingly easy to get at on this model. All I had to do was wind out the fast focus eyeball until it was off. I guess if there was any nitrogen in there it is diluted now!

This revealed the ret still in the scope held in a circular metal collar by three tiny screws. 2 came out easily. The third was rusty and has probably been chimped by earlier attempts to fix it by person/s unknown as I cannot get a screwdriver to bite. If I can come up with a way of getting it out I will update further.

Cheers Rich

[Muskett]

Somewhere there is a scope repairer, but costs start at £50. Thats a bit heavy as its more than many a cheap period scope. Plus the repair might not be successful.

Old glass can deteriorate. Nitrogen helps stop mould forming. Cosshairs were once wire, sometimes just soldered to form a cross, other times stamped out cut to shape. The wires can go brittle and break.
Some of the metals used were soft and poor quality. Some tin pot and oxidise.
Basically cheap scopes made to a price can be quite fragile. Not all expensive ones do much better.

There is some luck involved. If you have a good one look after it, and store sensibly.