Just got a nice used one piece sportsmatch mount and it has a clear non threaded hole where the pin goes...is there a pin available
Thanks
Just got a nice used one piece sportsmatch mount and it has a clear non threaded hole where the pin goes...is there a pin available
Thanks
Ed - HW77 mk2 .22 + Vmach kit - HW80 mk1 .22 + Vmach kit - Webley Tempest 1979 -
https://www.harrisontelescopes.co.uk
A split pin if I remember. Measure the hole diameter and you should be able to buy a pin to suit. If not from Sportsmatch then off of eblag.
Thank you was hoping it was threaded to put a grub scew in
Ed - HW77 mk2 .22 + Vmach kit - HW80 mk1 .22 + Vmach kit - Webley Tempest 1979 -
https://www.harrisontelescopes.co.uk
It's a roll pin you need, not sure of the size though.
You don't really need one with the one piece unless its a cannon that it's going on.
A .25 HW80 so close lol
Ed - HW77 mk2 .22 + Vmach kit - HW80 mk1 .22 + Vmach kit - Webley Tempest 1979 -
https://www.harrisontelescopes.co.uk
I'm sure that I've got one at home that I don't use from a set of two piece mounts; I'll dig it out and measure it up tonight, and if it's the same size, you can have it.
Thank you
Ed - HW77 mk2 .22 + Vmach kit - HW80 mk1 .22 + Vmach kit - Webley Tempest 1979 -
https://www.harrisontelescopes.co.uk
Some are threaded, some use roll pins. The two threaded ones I have take standard M4 grubscrews, the others 4mm plastic roll pins - I didn't realise they were plastic until one bent and I had to take it out !
On the only gun that gives a problem (an HW99) I have replaced the roll pin with a piece of steel rod I happened to have lying around. I cut it a bit short, packed the top with a bit of kitchen roll (all high tech me ) so the scope itself compresses it. Been in place three years now with no movement or problems at all.
Alan
The dreaded Weihrauch recoil strikes again!
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk