HW97 internals identity please

[deejayuu]

These don't look completely standard to me but asking them that know. It's Blackline apparently.
Spring 231 x 20 x 3 x 28 coil x 36 lb/inch Seems sensible as is ME. Ends hand finished but a bit untidy. Thanks for looking.

[T 20]

Apart from the piston seal and top hat it all looks standard Weihrauch to me, Jules.

[Phil Russell]

Apart from the piston seal and top hat it all looks standard Weihrauch to me, Jules.

Agreed. Maybe, just maybe the spring guide 'inner' has been replaced with a better fitting one but I doubt it.
Cheers, Phil

[Murphy]

The guide looks standard.

IIRC didn't Vortek do red seals.

Or where they that cheap USA gun stock maker?

[buffalo]

Possibly an Oz seal???

[T 20]

Agreed. Maybe, just maybe the spring guide 'inner' has been replaced with a better fitting one but I doubt it.
Cheers, Phil

The guide tubes come in several ODs, Phil.

I have a big box of Weihrauch guides which were given to me by UKNeil when he retired, so I just mix and match them to whichever Spring and cylinder size I'm playing with.




All the best Mick

[Jonjon79]

Possibly an Oz seal???

That's what I thought.

It all looks standard, maybe with an Oz seal 👍


That's not a bad thing. How does it shoot?

[deejayuu]

OK. Many thanks all. You must be very bright 'cos same thoughts as me

[Phil Russell]

The guide tubes come in several ODs, Phil.

I have a big box of Weihrauch guides which were given to me by UKNeil when he retired, so I just mix and match them to whichever Spring and cylinder size I'm playing with.

All the best Mick

Thanks ... I did not know that. My experience of such guides has been limited to the 97 and although I consider them a vast improvement over the old splayed metal type as used on the early 77 you could describe some as a fairly loose fit.

Cheers, Phil

[Geezer]

Another vote for an Aussie seal.

https://www.customairseals.com

[Bruno27]

Maybe my dodgy eyes, looks like barrel not // to action?

[deejayuu]

Thanks again for looking/support. Spring sloppy in piston and twangy so sleeved with plastic which softened it nicely. Removed 3mm power/slip washer too. 11 ME so fine for the mo'.