Page 2 of 2 FirstFirst 12
Results 16 to 18 of 18

Thread: Sharp ace strip instructions - anyone know where I can find them?

  1. #16
    Join Date
    Dec 2016
    Location
    leeds
    Posts
    2,061
    that's correct
    you can poke a bit of dowel down the tube and mark it on the lever pivot hole then lay lever and piston out and roughly set it to that

  2. #17
    Join Date
    Jul 2006
    Location
    sheffield
    Posts
    6,693

    Unhappy

    Quote Originally Posted by I. J. View Post
    This may help.


    IIRC the joint between 24 and 25A is very hard to see. I thought it was a one piece, sealed, unit. Its obviously not.

    The pump rod (21). Measure the distance carefully between the pump face (19) and the hole at 23 as this is adjustable (22). This will help you get the 'lock up' of the fore end right on re-assembly.





    HTH
    Ian

    This is the sheet that came with my Ace, Can't find it anywhere though!


    John..
    for my gunz guitarz and bonzai, see here
    www.flickr.com/photos/8163995@N07/

  3. #18
    Join Date
    Nov 2001
    Location
    Blackburn, Lancs. (under a bridge)
    Posts
    22,944
    Quote Originally Posted by johnbaz View Post
    This is the sheet that came with my Ace, Can't find it anywhere though!


    John..
    I didn't nick it !
    Founder & ex secretary of Rivington Riflemen.
    www.rivington-riflemen.uk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •