Old?unusual multi pump rifle U.S.A. opinion please

[--ped--]

you have the early check valve with an o ring one is in the seal kit

[T 20]

you have the early check valve with an o ring one is in the seal kit

I may require some quads at some point Ped --- do you do these separately ?





All the best Mick

[--ped--]

i think i have plenty can always order another batch in if I'm low
how many do you need

[T 20]

i think i have plenty can always order another batch in if I'm low
how many do you need

I think 3 will do for now, Ped.



All the best Mick

[--ped--]

i have about 20 in stock Mick

[--ped--]

i am after a few 140/147 bits i need a 4th variant trigger block a 147 breech loading sleeve and probe a pump arm/forestock and a stock

[T 20]

i have about 20 in stock Mick

Nice one, Ped.

Btw, I have replied to your post on the UKCAF regarding prizes --- hope it makes sense to you ?

[JOHN K]

[ped there is a chap on the other forum on the same topic who has some spares..
Atb John.

[--ped--]

I saw it Mick will get them in the post tomorrow
cheers John will have a look

[deejayuu]

Sincere thanks again for all support. This is getting quite exciting now.

[deejayuu]

Thanks to the good support on here and a seal kit from Ped got around to assembling the 140.
Wow! Wow! What a great fun thing it is.
Came as part of a job lot and did nothing with it till now. Makes power easily and really accurate. Rang the 6 mm bell challenge at 15 yds after a few ranging shots.

Could a white spacer be 3d printed to replace the piece missing from front end.

[--ped--]

I think one of the US suppliers has them (could be precision pellet) but I was looking at milling one in ally and one in brass but not sure if it would be viable to do

[45flint]

I think one of the US suppliers has them (could be precision pellet) but I was looking at milling one in ally and one in brass but not sure if it would be viable to do

Trivia, the brass spacer for the Crosman 108 was made of brass.

[deejayuu]

Just needs an end plug behind the loading port/probe. Easy enough but someone may have a spare.

[DT Fletcher]

You will want this. Has ever scrap of paper Crosman ever published on the subject.

https://www.amazon.co.uk/Crosman-Com.../dp/1499555008

Regarding the barrel spacer. I've seen some shops that have this but usually black not the white. The Crosman service shops never had any of the special parts for the Sears, Wards models.

Yes, the model Town and Country 107/108 had a machined brass barrel spacer.

Regarding other sourcing. I suspect that this type of plastic extrusion is available off-the-shelf for some special commercial applications. Might be worth a look to see if something could be found in a plastic/fixture supply house.