Fitting MFR MK IV Trigger

[DAR]

I just received the new design MKIV trigger cassette but without fitting instructions. There is also nothing on the Theoben site. I've asked them over the phone but as I did not buy it from them direct they are a bit busy to help although they are going to send me a set-up sheet.
So my question. Does it fit back exactly the same way as the original. ie, bolt locked back and trigger pulled?

[verminhunter]

Best to speak to Ben Taylor.

[verminhunter]

Lionel's had one or two fitted to his guns and say's their the mutts nutts those new triggers from theos,I tried it at bens and yes it superb,really nice,but to be honest the Rapid mk2 has one of bens on it and I really like that and the MFR's trigger is nice too even though a couple of lads have complaind about their's but mine one's lovely,guess it's luck really.

[Snapshot]

I was considering one of the new triggers but Ben's done himself out of a job by setting up the standard one so nicely. All it really needs is a better trigger blade and I've got DAR's unwanted BAR stainless steel one coming to sort that out.

Jonathan

[DAR]

Nobody fitted one themselves?

[DAR]

BT will sort it out. Apparently you need more than the trigger cassette. You also need a new hammer to match which Theoben failed to tell me about. BT will machine the existing one.