Umarex S&W 5/686 with an adaptor and good suppressor?
Modified Crosman 600.
Umarex S&W 5/686 with an adaptor and good suppressor?
Modified Crosman 600.
You can get adapters for both the Umarex Beretta 92 and CP88 which take the standard 1/2" UNF moderators. This does significantly quieten them- I had one on a CP88 I used to own and it worked well. The adapters for those are held by a single bolt only, so best to use a small, light mod...a long heavy one can cause mod droop Never owned a 92, but the adapters for them fit over the muzzle and secure with a grub screw. These work well according to what I have read, and really cut down the CO2 crack.
SMK CP2 good value.
Mag and silencer included.
Rifle barrel too if you want to convert.
I have found another way to overcome the noise drawing attention to yourself bit and tried this yesterday, wait until your neighbours are mowing their lawns seems to work well, they’re making more noise than I am so can’t hear me, even if they could and how can they complain
CP99 is a great little pistol & I have one, thought Shaun iSP made a Mod for it but just asked him & not so, was another Sean mentioned on here a while back ?
Like the mower trick
You can get an adapter for the CP99 pellet model that allows you to fit any 1/2" mod straight on- it may also fit the CP99 sport. Again ,this is a single screw hold, so a short light mod is best. Here's a vid showing the setup in action: https://www.youtube.com/watch?v=93bu8UiVdkg
Our sponsors sell the adapter here: https://www.jsramsbottom.com/walther...r-adaptor.html
I tried a 3D-printed adapter and silencer on a nickel 92 - picking up on the need for something light due to the single fixing.
The pellets clipped the silencer.
The issue wasn't the quality of the printed adapter/silencer, but the fact that the nickel 92s appear not to have a really square/flat front face to which you bolt it. The silencer was visibly out of alignment to barrel.