1" dies

[TALL]

got my hands on some CH-4D dies SNIDER, MARTINI, GRAS,
turns out they are 1"X14 threads
a bit stumped as to how I get these to work,
I have never seen a 1" threaded press or a 1 1/4" to 1" convertor,
has any body else run it to this,
thanks,
T

[andrew375]

4 options I can think of, all require access to a lathe or know someone who does.
Can you lose 1/8" off the diameter? If so re-thread them to 7/8" unf.

Get a lee turret press and have one or more holes opened out to 1" unf.

Get a Lee press with the 1 1/4" die head and have the 7/8" adapter bored out.

As above but get some sleeves made 1" unf inside 1 1/4" outside.

[TALL]

HI ANDREW,
I have a LYMAN SPARTAN press I think I will get that bored out and taped 1"
best I can think of,
T

[TALL]

HI TAC
this was not about SNIDER reloading, SNIDER DIES WHERE JUST ONE SET OF A FEW THAT I GOT,
WHICH ARE 1" THREAD,
the 1" part is the problem, not the reloading part,
but thanks for your input,
T

[tacfoley]

HI TAC
this was not about SNIDER reloading, SNIDER DIES WHERE JUST ONE SET OF A FEW THAT I GOT,
WHICH ARE 1" THREAD,
the 1" part is the problem, not the reloading part,
but thanks for your input,
T

Ah, right. I'll pull my comment so.

[Glevum]

CH4D do a press that takes 1" dies.

They also do 1 1/4" to 1" bushings