6mm type loading

[CROWMAN]

Can more experienced members who have 6mm, 6mmBR, 6mm Dashers etc inform me as to the reloading.
Can you buy the cases for any of them or do they all need to be formed from other cases, also how about powder amounts? heavy amounts?
So in general I'm interested in a calibre of this type which provides excellent accuracy combined with ease of reloading and average costs.
Thanks for any replies.

[JB101]

With regards 6mmBR in my experience I have tried neck turned and non turned cases with no real difference in terms of accuracy.
I have found that the neck turned cases do not last as long before the neck starts to split.

My 6mm br is std chamber whereas my 6.5x284 is a tight neck(291)barrel. So I have to turn all the cases for it - I would not go down this route again.

[Triple G]

If you’re shooting out to 600m, then I don’t think you can go wrong with the standard 6BR.
https://accurateshooter.com/cartridge-guides/6mmbr/

[CROWMAN]

Thanks for the link.
I am mainly restricted to 200 yards, but a great article to read and digest.

[Triple G]

If you are shooting up to 200y, want a 6mm and are chasing accuracy, then look no further. It is widely acknowledged to be the Daddy of all cartridges as far as short range accuracy is concerned.
https://www.accurateshooter.com/cart...guides/6mmppc/

[JB101]

Just make sure you get a 1 in8 or thereabouts barrel.
I never bothered fireforming the cases, load it up with N140 if you have it quite economical to shoot
90-100 grain bullets.

Have a look at the 6mm dasher build by thibben