Can anyone assist plse.

Thought I’d spend the evening on a learning curve and strip my old MK2.

It looks ( by the crud and lack of witness marks anywhere as though it’s never been apart. First job I’m trying to remove the cocking leaver pins, the one on the trigger block is hollow, next one forward holding the linkage is solid.

I’m using a brass drift and 2-27 nylon hammer , neither will budge even slightly. The hollow pin left side ( tap lever side ) Trigger block has a thicker diameter than its opposite side , I’ve lubed with WD but no movement.

Am I right in saying they should knock out left to right ?

Both are absolutely solid but the lever works ok.

Any ideas please?

I’ve given them a good whack , I really don’t want to try a big hammer though.

Edit : Gun is a GD prefix if that’s meaningful at all ..

Thanks