GTS break barrel

[cooper_dan]

Did you make the stock, Dan?

Yes, 3D printed in multiple pieces. It's not very good but as long as it roughly holds things in place it will do for now!

[MartynB]

Been an interesting journey

[TonyL]

Time for an update!
Recoilless break barrel V2 has been put together. Currently shooting under 6 ft-lb and in a temporary 3D printed stock. Next step is to strip it all down and inspect all the parts. Then rebuild it, sort out the weird vibration, and start power development.

Yes, 3D printed in multiple pieces. It's not very good but as long as it roughly holds things in place it will do for now!

That stock will more than just "do for now", Dan.. Looking good. Hope the future development all goes smoothly to plan. And when the rifle is ready for launch and "mass consumption" don't you go binning that stock......it'll earn its place in airgunning history and become collectable.