Mk4is power problem.

[woodpigeon]

Run my mk 4 over my combro yesterday and it’s putting out about 9.8,would a duff battery cause this??

[scoots]

Have u checked the power settings mate

[Murphy]

That's unusual.

Electronic Daystates are normally over.

They are the HW80 of PCP's.

[woodpigeon]

Have u checked the power settings mate

Says hi power on info screen

[Shed tuner]

more likely crap/gunge on the hammer

[scoots]

Charge it for 16 hours and see what the voltage is once charged...it should also say ip voltage good when u plug it in, if it says anywhere over 7v when charged and it's still low on power then I'd suggest maybe a service...or a seal is needed.

[woodpigeon]

Just been doing a little research and battery can effect the power as does the 0 ring on the pellet probe.

[scoots]

I charge mine religiously once a month whether I've used it or not....start with a good charge n see how u go

[woodpigeon]

I charge mine religiously once a month whether I've used it or not....start with a good charge n see how u go

Will do👍

[scoots]

Keep us posted

[cornish kev]

I charge mine religiously once a month whether I've used it or not....start with a good charge n see how u go

As do I.

[woodpigeon]

Charge it for 16 hours and see what the voltage is once charged...it should also say ip voltage good when u plug it in, if it says anywhere over 7v when charged and it's still low on power then I'd suggest maybe a service...or a seal is needed.

It does say that,what’s ip voltage?

[scoots]

As do I.

[Jesim1]

It's been mentioned, but worth reiterating as it's very common - swap out the O ring on the pellet probe.

[woodpigeon]

It's been mentioned, but worth reiterating as it's very common - swap out the O ring on the pellet probe.

What size do I need