Just bought a hawke fast mount scope for my tx200,av got a 1 piece mount but ya think be ok use the 2 piece mounts that came with the scope ?
Just bought a hawke fast mount scope for my tx200,av got a 1 piece mount but ya think be ok use the 2 piece mounts that came with the scope ?
I use 2 piece on all my springers with no issues.
Master Debater
Yea tx200 not that much recoil really,its a hawke scope so mounts should be decent quality.
Depends on the amount of recoil & quality of the mounts.
If they're single strap mounts I'd chuck them & fit either double strap or a one piece.
The TX I had was pretty lively, one of the reasons I hate them.
Using two piece mounts on a TX here just fine. Plenty of competition shooters I know do as well.
The only TX I have known 2 piece mounts move on was a TX200SR, much to my embarrassment ... a one piece mount solved the issue.
Cheers, Phil
I used the T04C Sportsmatch, (6 screws per ring), two piece rings to mount my 3x9 40 mm Hawke scope. The rear ring uses a stop pin that I pushed to the rear when torqueing the 2 base screws. With the two piece rings I can space them to match the scope tube. I have about 50/75 shots through the HW95L and these rings seem to be secure. Good luck.
Last edited by Travis299; 16-08-2020 at 01:38 AM.
IMO A one piece mount just looks more robust
I would say it also depends on the scope and it it has a sidewheel for a side focus scope .
Some side wheels are quite large and won't fit on due to the mount if using a one piece mount .