may also be employed in conjunction with a drawn reciprocation dingle arm, to reduce sinusoidal repleneration
Are these the same item? Obviously they’re matched when machined at the factory on individual guns but the blocks are the same dimensionally?
Guest
Same part numbers in the Chambers spare list.
BE002
Back block - ONLY sold with the cylinder, NOT sold as a separate item - please go to the Cylinder listing.
https://www.gunspares.co.uk/products/24562/HW35/
https://www.gunspares.co.uk/products/24562/HW35/
may also be employed in conjunction with a drawn reciprocation dingle arm, to reduce sinusoidal repleneration
Thanks bighit, I didn't think of the old Chambers part number cross-reference trick!Originally Posted by bighit
Guest
It comes in handy sometimes .
Administrator
HW77 and HW97 back blocks are also fit the HW35.
may also be employed in conjunction with a drawn reciprocation dingle arm, to reduce sinusoidal repleneration
I think I might have most of an HW80 ... but could be made from a 95, a 35, a 77 with a cylinder from the 80 at the centre of it.
Registered User
If you need a back block just drop me a PM. Mach 1.5
may also be employed in conjunction with a drawn reciprocation dingle arm, to reduce sinusoidal repleneration
Thanks for the offer Mach, that is very generous, but I was asking because I have now got a 35 back block and a 80 cylinder... just need to take a little metal off the end of the 80 cylinder and it should line up nicely.
Posting Permissions
Reply With Quote