ROA Axis Pin

[tacfoley]

https://drive.google.com/file/d/1QyU...ew?usp=sharing

Just received my purchase! Is it anyone on here selling these? Anyway certainly looks good. I suppose these pins will always be inherently weak at the locking screw notch and time will tell but I'm pleased so far.

I bought mine about a year back - all-over polished, they look v. spiffy. They are only weak if, like me you lend the revolver to somebody who takes it to pieces and reassembles it without turning the locking screw. Then tries to ram a ball - the pin backs out and bends under the pressure.

I tried to get a local company in St. Ives to make a some a few years back. Sure they would - I had to buy at least ten and they worked out at about £80 each... I didn't go any further with it.

[Turnup]

I bought mine about a year back - all-over polished, they look v. spiffy. They are only weak if, like me you lend the revolver to somebody who takes it to pieces and reassembles it without turning the locking screw. Then tries to ram a ball - the pin backs out and bends under the pressure.

I tried to get a local company in St. Ives to make a some a few years back. Sure they would - I had to buy at least ten and they worked out at about £80 each... I didn't go any further with it.

Yes - been there and done that. My fault entirely. Those nice folk in Fulton's straightened it out for me on the spot. I was a little worried about it being weakened but it has survived the past 20 odd years of use.

[steve medlock]

Chaps,

I'm sure I've done it many times before but I can't seem to remember how to embed photos in posts on here. I can do links fine but not embed!

Any help much appreciated!

Steve

[Turnup]

I believe that apart from sales you cannot embed pix - this is to save storage on the server. Just put up a link.

[steve medlock]

Thanks Turnup - I'm sure that must be the case. I've just manged to do it on the Collectable Airguns section but can't make it work on the BP section.