It can't be any good can it? It's not expensive enough
Seriously, it's tubing, concentric pistons and probably ball valves. Is it complex manufacturing from an engineering point of view? I think not.
Be sure to get a filter/dryer before using it though.
Walther CP-2 Match, FAS 604 & Tau 7 target pistols, Smith & Wesson 6" & 4" co2 pistol, Crosman 1377,
Baikal IZH 53 pistol, Gamo CFX Royal,177, Umarex SA-10 CO2 pistol.
BSA Ultra Multi .22 ( Falcon Merlin 10x42T, `Tweaky` reg, HW mod, Cobra Merlin+Dipol L3 ), Skan M32 .177 (3-12x44 mini SWAT), Alros Trailsman .177 (Simmons WTC 1.5-5x20 , `Tweaky` reg ), Steyr Evo 10e and a Daystate Pulsar. 177..
Hello, how are forum members finding these pumps?? are the connectors suitable for your fill probes ??? I found that the Kwik fit are not the same as best fittings and the threads are all metric, I have an adapter coming to screw into pump hose and take a 1/8 BSP thread, which are most fill probes we use except maybe a chinese PCP,
Mine is the daystate/quick connector type, My best fittings adapters fits mine great, I filled a 200 cc bottle up very quick compared to the other pumps I've used in the past, Normally you get to about 150 bar then it's like trying to dig an hole with a space hopper, This did get harder as more air went in but it filled rather quickly, I was quite surprised how well it worked,
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
Pretty sure that all the Chinese pumps and things are metric unless stated bsp thread size as some do but like you say there are adaptors out there that are compatible but will probably cost more than this pump itself but as all my fill probes are quick fit then i have no problem with the supplied fittings and i do like the quick fit tyre inflator. Put a adaptor or moisture trap at the base of the pump and use any hose fittings you already have,,
Hw77+7