Viper connect and connectamount

[Lucky Luciano]

Not sure if this has come up before but here goes.

Once the Viper connect 24 or 32 is attached to the connectamount the range numbers on the edge of the range wheel are obscured by the mount, so the question is can you get a ready made sticker for the flat face of the range wheel which corresponds with those ranges on the edge of the wheel?

Apologies if the above is not clear/terminology.

Luciano

[bighit]

this may work but not cheap.

http://www.scope-werks.com/viewitem.php?productid=156




Rowan Engineering does them, partway down the page .https://www.rowanengineering.com/products4.htm

Here also http://www.rangesports.com/acatalog/...et_labels.html

[Lucky Luciano]

this may work but not cheap.

http://www.scope-werks.com/viewitem.php?productid=156




Rowan Engineering does them, partway down the page .https://www.rowanengineering.com/products4.htm

Here also http://www.rangesports.com/acatalog/...et_labels.html

Hi Bighit

Thanks for this I will look further into it.

My thinking was a circular sticker that went at the end of the turret with a dash and meters and indicated the range in a similar way to a car speedo, so turn and align to marker on the mount which could even be the gap holding the top part of the mount to the bottom.

Luciano

[bighit]

Hi Bighit

Thanks for this I will look further into it.

My thinking was a circular sticker that went at the end of the turret with a dash and meters and indicated the range in a similar way to a car speedo, so turn and align to marker on the mount which could even be the gap holding the top part of the mount to the bottom.

Luciano

I see . not sure if I have seen any like that .

[Lucky Luciano]

I see . not sure if I have seen any like that .

Yeah me neither - it is just the downside of the connectamount which obscures the edge dial of the viper connect, thought this might be a neat way to overcome this.

Cheers Luciano