Are the long transfer ports worth the safety and can they be made to shoot really nice? and was there only two manufacture's of flip up's. Are there any opinions on these actions
Are the long transfer ports worth the safety and can they be made to shoot really nice? and was there only two manufacture's of flip up's. Are there any opinions on these actions
I believe you are right on u/ls.
They both are derivatives of the mid-70s Walther LGR 10M match SSP, the first rifle to rival the FWB300S. Much of that was down to the SSP system, but clearly the flip-tap did not in any way impede high accuracy. Unlike mass-produced rotary taps, which did.
I like well-done tap-loaders and flip breeches. Even 57-style pop-ups. They are convenient, and very safe.
Unfortunately, they fall badly between two stools.
For the mass market, especially unrestricted in power, the sliding breech/comp tube shoots faster and harder. For the connoisseur, including in restricted markets, the sliding breech shoots nicer at a given power level. Which explains their demise.
I like sliding compression tubes and direct loading into the breech, very efficient, but I must admit the thought of a potential mishap and squashed fingertips gives me the creeps whenever I load these type of airguns.
At reduced power levels, the flip up type can be very good IF designed well in the alignment area. Otherwise they clip the pellet and accuracy suffers. At higher power levels there is too much lost volume which makes it harder to use stronger springs without becoming too slammy.
Hang on to your levers and barrels !
Last edited by dvd; 11-04-2021 at 06:17 AM.
I'm a fan of the flip up type. Obvious issues are TP length and scope height/length.
TP length isn't the end of the world. There are some break barrels with quite long ones which can shoot nicely. Scope interference is the bigger issue.
I am designing a fixed barrel version of my recoiless springer and am wanting to use a flip up breech. Potentially looking at 'flip sideways' as an option to avoid the scope issue.
I have no experience of the Webley but I've got a .177 and .22 Diana 46 and both shoot very well. The .177 is at UK power but the .22 was one of the last on the shelf out in SWS and is still at German power.
Nice accurate guns and I've had no issue with clipping of the pellet on either.
Dave
Aren’t all break barrels, flip-ups?
Would have a similar issue with scope length, in that the scope or sunshade could not go over the top, or you wouldn't be able to get pellets in. I guess a side loading rotary would work.
Still playing with ideas. Part of me just wants to be different, but if it compromises performance I'll settle for tried and tested
You might be getting these confused with tap loaders. In a flip up breech, the pellet is still loaded directly into the barrel. The "flip up" part is just an extension of the transfer port, the pellet doesn't travel through it so misalignment and pellet clipping isn't a consideration.
Cheers
Greg
Best made flip up I have used wasn't on an underlever but on the battery cranked Browning Airstar. Not so much a flip up breech, more of a flip up cover. When raised it revealed a slot for the pellet to be dropped into and sealed the slot when closed
Last edited by ken69; 11-04-2021 at 03:27 PM.