Help wanted with CP88 stripdown for seal replacement, please?

[charliemow13]

Putting it all back together I built everything up in the right hand side of the frame. The trickiest bits were getting the trigger blade spring back in place, and then slotting the safety bolt into place. A piece of thin wiper blade steel helped in both places, to wrangle the trigger bladespring back into place under tension and then to depress the valve so the safety could slide into place. Also useful to jiggle the safety clip thing (sorry cant remember proper name for it) into place on the safety before the frame was closed up.

[Neil54]

Putting the pistol in a plastic bag whilst taking apart catches the ball bearings and springs.

Check the lever with the brass screw that touches the caplet, make sure this isn't bent.
Adjust the screw firmly against the caplet but don't use any tool to over tighten. This usually bends the lever.