Does anyone on here get a bit deeper involved in the repair of standards, as I need a CS re-cylindering or repaired where it has cracked on the cylinder just in front of the trigger.

I might have a go myself but I am short of time at the moment, finishing my new build house for one thing and working a 50 hour week on top.

Obviously it it will probably need a cylinder from a bitted parts one with the same length cylinder.
I think if I remember correctly the cylinder is soldered to the tap/barrel?

Any help or suggestions would be gratefully accepted. I am a mechy engineer with my own lathe, so could do it when I have a bit more time, but its annoying me that its sat there not really being able to use it. It has already been reblued (not by me) so I dont mind about patina or finish on this one.