If you pm me your email address I will send you a copy of the original manual which includes a parts list and exploded diagram
There is also quite a lot of info on t’internet https://www.youtube.com/watch?v=AxO2OuwMT2g
Hi. I have an old Huntsman which I am trying to charge.
I have tried to put 3000 psi into it, but no joy.
I think the filler valve may be stuck as I have not charged it for 30 odd years.
I can not find any diagrams showing the valve body and it's parts, so as to get an idea of how it works.
The valve body is tight in the main air cylinder.
If anyone knows how this charging valve works, please let me know.
Any help or advise gratefully received.
Dave
If you pm me your email address I will send you a copy of the original manual which includes a parts list and exploded diagram
There is also quite a lot of info on t’internet https://www.youtube.com/watch?v=AxO2OuwMT2g
Last edited by ken69; 05-07-2021 at 07:15 PM.
after so long, and it being quite an early model, I'd be tempted to strip, inspect and service it before filling...
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
Info sent. This is only an 'if' but it's a biggie - my biggest concern would be that the rifle is actually full of air and the problem lies at the other end of the rifle with the exhaust valve or the hammer mechanism. Please be careful when stripping the gun just in case
3000psi = approx 207bar. Why do you want to fill to 3000psi?
The early Huntsman was designed to operate at c 140 - 150bar.
If you have managed to inject more than this then the rifle will not work because the pressure is too high for the valve to be opened by the hammer. I have known a Huntsman Mk1 or 2 charged to c 180 bar and the output was very low but increased with constant firing until pressure dropped to c 150 bar when it was 'on song'.
So... there is a real possibility that there is air in the rifle. I am sure someone can advise on the best safe way to release pressure
I have heard of people slowly undoing the fill valve and even releasing the fill end cylinder plug. But I have also heard of a cylinder end plug that suddenly released and punched a hole through a partition wall ....
So, whatever, take care!
Cheers, Phil
Phew, that's a relief.
Is the fill valve not a standard forstner fitting so that if you clamp the cylinder you can unscrew it with a suitable spanner? If I remember correctly, once the valve unit is off the cylinder end plug (don't forget the dowty washer) then the valve can be replaced as a unit (Best Fittings) or just the small valve O ring ... BS006 I think. It may be that this small O ring has 'welded' itself to the valve seat and is thus not allowing air to enter.
Daft thought: I assume you cocked the rifle before trying to fill it with air? If you don't then all air is vented out.
Cheers, Phil
I was using the rifle when the pressure dropped off. Hence trying to re-charge it. Early models did not have the Forstner fitting.
I have sorted the sticking valve.
Hammer and tapered drift, gentle taps progressively getting harder freed it.
Fitted a Forstner fitting with valve built in and charged it up.(Two valves in place)
Still unable to undo the main charging valve body.
Cheers Dave
Hi guys. Daystate rifle working fine. I also had to reseal my Titan cylinder.
I will put photos up, if interested.
Would someone tell me how to do it. In simple terms please.
Cheers to everyone who posted
Dave