Originally Posted by
Mark D
You have a Parker Hale steel silencer. You should have a stack of baffles, plus two flat washers and a short piece of spring.
Ideally you need a length of rod and stack the baffles onto each other so the slightly curved base piece sits in the first baffle and then just add all the baffles in the same manner. Then add a flat washer, followed by the spring section and then the final washer. Slide these into the body of the silencer and then screw down the cap.
You can do it with out a rod but it's a faff.
Hi Mark, yes I did all that as that's exactly what I had (see photo). I just wanted to know if that was everything or if some other bits were missing seeing he'd said there was nothing at all, he must be blind!!
Each disk was covered in some odd unhealthy looking powder of some kind too?
Thanks
Steve
Steve
I've had Good deals & great info from many in this forum.