Protek and Tell2 - Breech seal question

[ChasP]

I had the good fortune to recognise Protek Supplies as I trundled along the road yesterday - it pays to have a photo of your shop front on your website!
I was on a 200 mile round trip to pick up some winter tyres for a trip to Germany. I couldn't believe I was outside Protek, and it was open! I've bought bits from them over the years and felt like a kid at Christmas as I pushed open the door.
Amongst all the glorious stock that I'm fairly familiar with from the website, there in the display cabinet, right under my nose, was a little Tell 2, which I more or less had to have. So it came home with me. I've had it in bits to see what's what - as far as I can. There seems to be a fair old gap between the lower half of the breech and its seal - has anyone experience of reviving or replacing this leather part? Any ideas?

[Maple]

- has anyone experience of reviving or replacing this leather part? Any ideas?

I needed to make one a few years ago. I shaped a piece of leather and glued it into the recess with evo-stik
After reducing the width to allow the cocking lever to close with a Stanley blade it shot with around the same efficiency as an original one that I used for comparison. Just that it worked was good enough for me as they are not really a pistol to use regularly.

[ChasP]

Just that it worked was good enough for me as they are not really a pistol to use regularly.

I think perhaps I'll leave mine as it is - it shoots, and they're only original once. I couldn't resist filing the bayonet fitting at the muzzle just a fraction, to get the front sight to sit at the top of the barrel, rather than a few degrees off.

Thanks for the tip though, good to know it's straightforward

[Benelli B76]

I have worked on a few of these, there is a particular water tap that has a replacement rubber washer fitted that fits exactly in the recess of the Tell 2 and also is the correct thickness. You just have to prize it out of the brass fitting. I also punch the seals out of polyurethane sheet with a sharp punch.

Baz

[IMG][/IMG]
[IMG][/IMG]

[ChasP]

I have worked on a few of these, there is a particular water tap that has a replacement rubber washer fitted that fits exactly in the recess of the Tell 2 and also is the correct thickness. You just have to prize it out of the brass fitting. I also punch the seals out of polyurethane sheet with a sharp punch.

Baz

That's great to know, much appreciated - I will look for something suitable. The leather is very hard and compressed and not making much of a seal at all, being nearly a century old!
When I next feel brave, I'll dig out the old seal - I was wondering if a slice off a wine bottle cork might even do an alright job..

[junglie]

That's great to know, much appreciated - I will look for something suitable. The leather is very hard and compressed and not making much of a seal at all, being nearly a century old!
When I next feel brave, I'll dig out the old seal - I was wondering if a slice off a wine bottle cork might even do an alright job..

i've replaced leather breach seals with the correct size o ring glued in with a hot glue gun, be sure to use the soft compound sticks & as it's nearly cool close the breech & you'll get a perfect seal then trim the exc
ess off. the soft glue sticks mean you can dig it out if not right first attempt or two till you get the knack of it, works really well.

[cloudr]

That's great to know, much appreciated - I will look for something suitable. The leather is very hard and compressed and not making much of a seal at all, being nearly a century old!
When I next feel brave, I'll dig out the old seal - I was wondering if a slice off a wine bottle cork might even do an alright job..

Don't try a wine cork - I did and it breaks up, nightmare! Tap washers work well though.