Hammerli master/single spares

[jinxs]

Hi, has anyone got or know where i can get a pop-up loading post/tap for a Hammerli master/single pistol please.
Grateful for any help,
Atb,
Steve.

[Obsidian69]

It's the older model without the over-travel stop but I doubt they changed the loading port.

I can measure that if you think it's the same.

[jinxs]

Hi Obsidian69, mine as the same model number D 452, so if you dont mind yes please , ive got another member who as one that has said i could get the measurements from be good to compare the two.
Many thanks,
Steve.

[Obsidian69]

You may need a diagram but let's start with raw data:

1. overall length: 1.751"
2. Diameter: 0.354 - 0.355"
3. Length of flat section: 0.858 - 0.859"
4. Width of 'pop-up' groove: approx. 0.11 - 0.12"
5. Diameter @ groove (not incl. flat section): 0.318" - 0.319"
6. Width @ groove (opposite flat section): 0.276 - 0.277"
7. Width (opposite flat section): 0.293 - 0.294"

Sorry for using Imperial but I couldn't be bothered going out in the cold to get
my metric Vernier.

[Obsidian69]

The issue you will have is getting the slot/detent in EXACTLY the right place so it doesn't shave lead off the pellets as they jump from the loading port to the breech.

PS. I realised I didn't give you centre of pellet hole to top so I'll do that sometime but I'm out on the razz tonight.

[Obsidian69]

Photos sent to your email.

[jinxs]

PM sent.
Cheers,
Steve