Tuning The Weihrauch Rekord Trigger
1.0 Adjusting the Trigger
The Rekord trigger is a two-stage trigger and is fine piece of engineering that was years ahead of its time. The following adjustments are possible:
• First stage travel
• First and second stage pressure
• Second stage movement (I also call this creep in this article)
Each of these adjustments is covered in the following sections.
1.1 First Stage Travel
Adjustment of the first stage travel is achieved by removing the action from the stock and moving the down-stand on the front underside of the trigger unit, see figure 2. The arrow shows the down-stand. To reduce first stage travel, the down-stand must be bent towards the rear of the trigger unit. I have done this by giving it a smart tap via a hammer and drift tool. Remember that this will reduce the setting position and sear engagement, so don’t reduce it too much. It is essential to maintain sufficient sear engagement so that the gun is safe and can take the odd bump without firing itself, otherwise the rifle would be very dangerous. Moving the down-stand forward will increase sear engagement and first stage travel.

Figure 2
1.2 First & Second Stage Trigger Pressure
This section deliberately deals with the pressure required to pull the trigger through both first & second stages as they are linked to each other. In other words if you increase the first stage pressure, the second stage pressure will also increase. The reason for the for this is that only one spring is used (part 51c), and the difference between first and second stage pressure is achieved by the difference in effective leverage between the front and rear rollers crimped into the top of the trigger blade, relative to pivot pin of the tongue/guide (parts 52a/52).
The adjustment is fairly straightforward; you don’t have to remove the action from the stock. All you have to do is turn the rear trigger adjustment screw (part 51a) clockwise to increase the trigger pressure, or anticlockwise to reduce it. If you reduce the trigger pressure too much, the trigger blade will not return if you release pressure on it during first stage travel. Also the second stage pressure can be too light making it unpredictable and dangerous.
The feel of the trigger as it breaks and releases the rifle piston is related to both the second stage pressure and creep. It is important to ensure that the trigger feels safe for you, even when you have cold fingers.