Crosman 2200 magnum Walnut

[norris]

I've got a 2200w here which is in a anniversary box aswell, Always fancied putting a scope on it but the dove rail dont stick up much, Are normal mounts ok to use on the top of these guns, Never tried before as I dont want to mark it, The condition is excellent all over and dont want to risk marking it, Only ever had a plink in the summer on the idd occasional day.

I used a single clamp one piece Sportsmatch to spread the load and prevent damage.
The two halves of the receiver aren't 100% perfect. One thing that I noticed when I pulled it apart all those years ago that it was slighty under tension.
Adding a scope mount could increase the tension causing stress to the diecast reciever sides.
It's an underrated an air rifle.

[madcarlos]

I used a single clamp one piece Sportsmatch to spread the load and prevent damage.
The two halves of the receiver aren't 100% perfect. One thing that I noticed when I pulled it apart all those years ago that it was slighty under tension.
Adding a scope mount could increase the tension causing stress to the diecast reciever sides.
It's an underrated an air rifle.

Cheers bud, Think I'll leave it as it is, Its not as if I use it much, Thanks.

[norris]

Cheers bud, Think I'll leave it as it is, Its not as if I use it much, Thanks.

You will have to keep an eye on it because I believe the material used in the side plates is Mazak which can suffer from rot.

[madcarlos]

You will have to keep an eye on it because I believe the material used in the side plates is Mazak which can suffer from rot.

One thing I've noticed is that there is a little play where stock fixes to metal, Didn't want to mess with the 2 screws/bolts as is only minimal, But are they there to tighten the stock to the action. Thanks.

[norris]

One thing I've noticed is that there is a little play where stock fixes to metal, Didn't want to mess with the 2 screws/bolts as is only minimal, But are they there to tighten the stock to the action. Thanks.

There's a bolt that runs from the butt to the reciever side plates, there's a flate plate the other end.
Another area that could cause a stress/crack failure.

http://support.crosman.com/hc/en-us/...C2200W-EVP.pdf

Scroll down to page 3 (I think it is), don't worry it's not the Sun.

Large flat bladed screw driver should tighten it.

[rapidresponse1]

looks very nice

[madcarlos]

There's a bolt that runs from the butt to the reciever side plates, there's a flate plate the other end.
Another area that could cause a stress/crack failure.

http://support.crosman.com/hc/en-us/...C2200W-EVP.pdf

Scroll down to page 3 (I think it is), don't worry it's not the Sun.

Large flat bladed screw driver should tighten it.

Thanks bud, I cant open that link with this tablet but I'll try with my other one when I'm on my days off, Been a little busy with work etc, I quite like these pumpers but just for fun plinking,

[Lumberjack]

Interesting thread this. I've always liked the little Crosman's. My 2200w has a gold '75 year anniversary' medallion set into the butt stock. The wood version has a much more substantial feel than its plastic brother (to be expected I suppose).

Does anyone in the UK still sell the 2100's and 2200's or are they now a thing of the past?

You made a nice job of it Norris. Looks exactly like it should.