The 3d picture was just something to aim for
Admin's pet.
The 3d picture was just something to aim for
them there springer's are soooooo addictive
Admin's pet.
Has not one but two workbenches in his shed
I did watch that one, forks wont be a problem as we can buy something premade for the job, other thing I'm figuring out is how I can make the reloading easier and potentially able to provide a bigger punch than what my normal hand draw could.
Worst comes to worst the Original 25s stock is still off, I can trace its outline and scale up where it's needed to be longer or beefier, maybe inlaying some steel plate for bracing.
I reckon we could make quite a cannon if we can get it to work.
You'll Shoot your eye out Kid
Admin's pet.
Has not one but two workbenches in his shed
Cheers, the mech should fit into a traditional sized stock which a can through bolt and add a plate for strength, just thinking how I can make something to do the draw and lock it into the mech, possibly with a Magazine to load a BB into the sling as its pulled back.
You'll Shoot your eye out Kid
Admin's pet.
The 2 front pins move when fired .....the trigger then locks the pins so you can load the ball bearing and pouch into it ....the two front pins holds back the bearing etcOriginally Posted by Segata
Admin's pet.
When the triggers released the pins go back to their normal cocked position
Has not one but two workbenches in his shed
I'm sort of getting an idea how it could work in my head, main workings of the recocking mech will be overtop to avoid fouling on the jaws as they lock closed and possibly trigger the mag as it passes and can be operated with a grip underneath to make operation less strenious.
I'm still full of cold and this Gum infection but I'll get some rough design sketches done to plan things out.
You'll Shoot your eye out Kid
Posting Permissions
Reply With Quote
