Quote Originally Posted by ggggr View Post
So I assume you will try to compress the spring and open the mouth with a drill bit turned by hand ? (or a reamer/ dremel/ conical stone?) So the ball will come out? Refit a spring and ball and pop the breech?
What I did on a Meteor that someone had jammed the plunger in without a spring, was to drill a small hole from the cocking arm slot and knock the plunger out the front with a punch. you wonk be able to see the hole after with the cocking arm refitted.
Once it is out and and you have you spring and ball ready to go back in you may be able to "pre pop" the breech a tiny bit then warm the block and put the ball in the freezer before fitting? Then once it is in a slightly bigger pop or 2?


[B]OR[B] Just buy a Diana 23 or Milbro 76?
That’s good planning … I’m just hoping it can be cured by a new latch pin .. there’s not much room to drill from the front, looks like spring and ball would have to come out from the front then making a fixing that would hold them might be really difficult.. converting to a chisel of some kind may be easier. Or find a cosmetically knackered 25 and swap the barrel!