G'day,

After much nagging from disciples of the Religion of FeinWerkBau I purchased an FWB 300S from a state target shooting association. In other words it is a club gun dating from about 1974 and has been used by very many shooters of all levels. Because the club gunsmith maintained all the guns it is in very good shooting condition and gave me quite tight groups straight out of the box in spite of my inexperience with an action that comes rearward. In fact the box in which I received it is likely the original FWB box in which it came from FWB! It has some very tiny rust 'specks' on blued areas and some equally tiny discoloration/staining/rust on the sliding breech. I suspect that it did not always receive a wipe down after each use to remove sweat and oil, but it's not too bad. The bluing seems pretty even too. What is the best way to deal with these tiny rust specks, hopefully without have to completely strip and re-blue it?

Advice would be appreciated,

Jim