Lads I messed up.
I hold my hands up,
I've dived into something not fully understanding what I was doing
I've got a pro sport that was a bit twangy.
I tried adding abit of grease to the spring guide (which was a slack fit) and it was just the same.
So I've made a spring guide on my lathe from delrin.
What I failed to imagine is how close to being coil bound the gun is with the standard guide fitted.
I can only imagine because I made a guide slightly thicker to add a touch more preload to the main Spring
The trigger will not fully engage.
So now I have a stripped down partially cocked pro sport and no obvious way of unloading the mainspring
Sometimes with this gun if your not fairly forceful when cocking the safely does not pop out.
And I have to recock it until the safety pops then It can be fired
Well I'm at that point but I cannot cock it until the safety pops out probably because of the new guide I made.
Can the trigger be adjusted to go off in this situation?
I dare not remove the set screw that holds the trigger on like this for fear of death.
Please can anyone offer a solution ? I'm out of ideas.