-
My Beeman HW40 clone isn’t too noisy. I do short range target shooting with it in my garage, and the noise doesn’t bother my wife and kids. That said, I designed and 3D printed a silencer for my wife’s Ratcatcher XL and have been thinking of how I could do something similar for my pistol.
EDIT - Just had a little play around with the HW40, and I can't see how you could fit a silencer without it fouling the trigger guard. I suppose you could use a push-in silencer that was a tight fit into the muzzle break, but you would need to remove and refit for every shot, and I can't advise trying to fit a silencer to a loaded and cocked pistol for obvious reasons!
Last edited by Chewy; 02-07-2019 at 06:44 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules