I'm looking for some advice if anybody can offer any.
I bought some once fired RWS brass a while back for my .308, full length resize using rcbs dies on a lee single stage press. Then trim to size using a lee trimmer.
Problem is now I've come to use them they won't chamber. I havent loaded them, just tried to chamber the empty case and the bolt wont close.
I've stripped and cleaned the die, and tried adjusting it in the collet, so the shell holder is now almost touching the die, still no better.
So is my brass junk? Should I buy some new brass and load that? Or can anybody offer any solutions that I could try? Cheers.