Size help for trigger mod

[Chilly]

I want to sort out the trigger on my viper and need to replace the roll pin with a solid pin.
I intend to replace the roll pin with a piece off of a brill bit.

Now my question is what is 3/32" in milimetres?
I have found on the web that it's .6mm but am not sure if this is true as that would seem rather small

TIA

[roblade]

i think 3/32 is a lot less than 6mm!!!! one inch is roughly 25mm so 6mm would be aprox 1/4

i think the metric size would be roughly 2.4mm though am sure others will tell me if im right or wrong

[Chilly]

sorry roblade i should have put a 0.6 instead of dot 6, well all the web site said was .6
All my drill bits i have are all marked in milimetres, i remember when i was young my dads drill bits being marked as 3/32" and so fourth

[Livesley165710]

1 inch is 2.54mm 1/32 would be 0.079mm 3/32 2.381mm
Steve

[Pat...]

Originally posted by Chilly

I intend to replace the roll pin with a piece off of a brill bit.

And what size pliers will you be using to hammer the piece of drill bit into your gun with?

[Chilly]

I'll have a word with Ben taylor first i think

[krazy_horse]

Yes, 3/32 " = 2.38125 mm

JB

[roblade]

now wher oh where did i put that 2.38125 mm drill bit????? prefer to use the HSS bits myslef though must admit they can be a bit of a bore

[Liam]

Originally posted by Livesley165710
1 inch is 2.54mm 1/32 would be 0.079mm 3/32 2.381mm
Steve

sorry to be a b1tch but i think you'll find that 1 inch would be more equal to 25.4mm

[Sid]

Originally posted by Chilly
I want to sort out the trigger on my viper and need to replace the roll pin with a solid pin.
I intend to replace the roll pin with a piece off of a brill bit.

Don't be stupid

[Chilly]

Any suggestions on what i use to replace the roll pin with then Sid?

[krazy_horse]

I think some welding rods may be 3/32", this will be mild steel, i have asked my Dad to have a look at his works place to see if he has any in stock.

JB

[Chilly]

Thanks mate

Going over Ben taylors later, i'm going to ask him about it.

I just want to get rid of this dam wobly trigger as it's bugging me now and affecting my shooting

[krazy_horse]

Dad has just phoned, and the welding rods are just a smidge over 3/32" he said its about 4 thousands of an inch too big, which is 0.00635mm i believe, so this could easily be sanded down with some emery (so) paper. If you want one let me know and i'll send one over to you when i'm back next week,

JB

(ps it is def. mild steel)

[Chilly]

Ok thanks mate, I'll let you know this afternoon when i return from ben's if that's ok.

I'm off to check that new field i have to shoot in a moment,spoke to a friend who shoots on it and he said that it crawling with bunnies, I'll let you know what i find