Mines got a co2 cart. in at the mo. - so can't look just yet, but if you look here :
http://www.gunspares.co.uk/shopdispl...cts.asp?page=5
it would appear to show an 'end seal' marked 'PW098' @ £2.81
hope this helps.....
right ive just got a pistol a gamo pt80
i just put a co2 capsule in it and tightened it up and it was leaking it out so my question is should there be an o ring or something up inside the gun where the capule connects to seal it any help much appreciated
Last edited by astraman1; 20-07-2008 at 04:48 PM.
Mines got a co2 cart. in at the mo. - so can't look just yet, but if you look here :
http://www.gunspares.co.uk/shopdispl...cts.asp?page=5
it would appear to show an 'end seal' marked 'PW098' @ £2.81
hope this helps.....
I suspect the seal (orange bit) is defective. Maybe damaged or too hard. Just fit a new one and away you go. Every time you fit a new CO2 just look inside to make sure it's clean and wipe the top of the CO2 with your finger in case there is contamination.
atb Phil
Just an add on to Phil's advice, put a drop of Pellgun Oil on every other capsule, it will help make a nice air tight seal, and will prevent the pistols seal drying out.
Jason
Fancy shooting your air pistols & rifles a bit more, then guy's & gal's come visit us at theUBC for loads of fun competitions for all types of air pistols and rifles.
this is what yours should look like....