It's a 'Standard Club' 1936-39, and in that condition I would say £100 to £150 being conservative and a premium for the sight if it is fitted well.
Ormicron
BSA Club underlever .177 calibre Serial No. C2280.
I wonder if anybody could give me any information about this rifle and a rough valuation. The rifle itself is 43.5 inches long with a stock length of 13.75 inches. It has a power output of 9.4 ft/lbs. Apart from non-existent blueing, it is in good condition. As far as I can make out, the only thing that is missing is a screw to the peep sight (as you can see in the photos). Thanks in anticipation. Old Bull
Last edited by Old Bull; 30-11-2010 at 06:03 PM.
It's a 'Standard Club' 1936-39, and in that condition I would say £100 to £150 being conservative and a premium for the sight if it is fitted well.
Ormicron
You have quite an uncommon gun there. One of only 2530 guns made with the 'C' prefix during the period late 1935 to 1939 and the outbreak of WW2.You gun is a number 4 club, and the 'C' prefix guns replaced the 'CS' prefix guns which were manufactured during the period 1930-35.
The foresight looks like a replacement, and the elevation wheel on the rearsight is from a later cadet major or airsporter Mk1, however the No. 21 aperture sight let into the stock is a lovely addition, and was added for club shooting at targets and bell targets.
Model details would have been photoetched on the air cylinder, however all traces would have disappeared along with the original bluing. Maybe the gun might be a candidate for a polish and reblue as in the case of your gun, you would probably add to the value.in the condition it is in at the moment I would value it at around £120-£160 as it is an uncommon model.
All the best
Lakey
Unfortunately that looks quite badly rusted and someone has been over it with rust remover which has stripped the finish, the stock also looks like its been refinished a while ago and I'm not quite sure about the peep sight.
You'll probably get £80 for it?
Richard
My learned friends are convinced about the sight.... I'll still stick with my valuation thats a lot of pitting to be polished away
Rich
Yes thats a std pattern BSA club. In excellent nick it could easily fetch £300 to £400 but it looks very badly pitted.
As you lose the blue down the years tiny pitting takes place. It appears to have an almost even coating of pitting which will hammer down its price quite badly. £75 to £80 maybe.
There's only one way to sort this out....FIGHT...
"AND APERTURE SIGHT" .......being the difference
BSA woodwork in good order normally fetches between £30+ - £70+ depending, with the lowest price seemingly being for a 20's heat impressed type, then the later 'BSA' impressed type, with early pistol / straight hand types next, and Lincoln Jeffries ones at the top.....interesting trade / retailers plates and stamps, and clear markings all help, and if someone was to put for example, an early factory presentation stock (in-letted plate /plaque with details, selected walnut etc.) on to the bay..I could see it going over the £100 very easily
Stocks factory inletted, and fitted with factory supplied early (model 21-21b) apertures.....I would say £80 is very fair if in good order.......try and find a sight alone for less than that as they very, very rarely come on the market....I will put my hands up and say I personally have bought complete rough guns just to get them
.
I looked at quite a lot of CS models prior to buying mine and from my experiences your rifle is probably worth £150+ with that peep/diopter sight despite the non standard parts fitted
As Lakey says, the 'C' - Club model was quite rare and the peep sight alone would be difficult to source and perhaps pricey to buy
I fully restored mine as the photo etching had long gone.
There is little stamping on the metalwork so dressing and polishing out the surface pitting is achievable. It took me 9 - 10 hours to prepare mine for a reblue but the results were well worth it
John
hold me back !!
Lets add it up
Stock = £60 approx
No 21 Aperture sight = £50 minimum
Stock bolt = £5-£8
rearsight = £15-20 maybe
Push button underlever = £10 minimum
Auxilliary cocking lever = £8 - £10 minimum
Cylinder and tap assembly = £20 - £25
Piston = £15 all day long
Spring = £5
Trigger block = £20 at least ( especially with rare 'C' prefix)
Trigger guard £10 at least
Well these prices are easily achievable on fleabay, so what is the total for the gun based on these prices ???
Over £200 on scrap value alone !!!!!!
Is that realistic or am I on some sort of pipe dream. I see that prices 'the bay' makes, so valuations on this gun of sub £100, are way out IMHO
Room for thought......
Lets see what others think ??
Lakey
Oh and I forgot to include......
Repro foresight = £5-£10
Underlever catch post = £3-£5
Pair of trigger guard screws = £5 minimum
Underlever pivot pin and aux cocking lever pivot screw = £2-£3
Original wooden stock bolt cover,spring steel oval washer and original screws = £20 + ( how many 100's of guns are missing this - and originals are Rocking Horse Poo!!)
See how easy I can mount up........