I reckon thinking too much. Co2 guns run at an average of 850psi, depending on ambient temp.
i wonder what sorta pressure a co2 gun runs at ,
i know the capsule is about 800psi, but at the neck its a lot less, as it only about an 8th of an inch,
or the cap would blow out , so given that only a tiny squit goes into the mech , what pressure would it be using .
am i thinking to much
Getting Old
I reckon thinking too much. Co2 guns run at an average of 850psi, depending on ambient temp.
Weihrauch B&C HW95K, B&C HW35K, BAM B26-2 venoman custom, QB78 DL custom.
You ain't so big, you jus' tall, tha's all.
http://ukchineseairgunforum.myfreeforum.org/index.php
you think the plastic blowback cylinder on a tan wit can take 850 psi
i bet is could'nt take 50
ok i'll get me coat
Getting Old
Angrybear is 100% correct of course.
It does not blow out because - it's 850 p.s.i.
PSI = Pounds per SQUARE INCH.
Geddit?
If for the sake of simplicity the piercable area were square, 1/16th of an inch square, then the area would be 1/16th x 1/16th of an inch square (0.00390625 of an inch) thus the actual force on the piercable area (the number that came before, multiplied by 850) would be 3.32 lbs... not a lot I don't think.
**WANTED**: WEBLEY PATRIOT MUZZLE END; Any Diana/Original mod.50 parts, especially OPEN SIGHTS
Weihrauch B&C HW95K, B&C HW35K, BAM B26-2 venoman custom, QB78 DL custom.
You ain't so big, you jus' tall, tha's all.
http://ukchineseairgunforum.myfreeforum.org/index.php