Hello Markmac
The rear blocks are all the same for the Anschutz rear dovetails, it is the foresight block which is different.
Regards Adrian
I have just fitted a set of Anschutz air rifle dioptres to a project rifle (11mm scope rail) I am using for Bell Target.However the rifle is shooting exactly 4 inches low at 6yds.
I need a set of risers for the rearsight but what size and type ?
I have been looking at Intershoot SE Boost risers at 12.5mm rise but they offer 2 options for Anschutz
Do I need the Anschutz 1913 type/
OR
the Anschutz 1813 or Earlier type?
Life without happiness is no life at all.
Hello Markmac
The rear blocks are all the same for the Anschutz rear dovetails, it is the foresight block which is different.
Regards Adrian
Thanks Adrian, Does that mean it doesn't matter if I order the 1913 set as I am only intending to raise the rearsight?
Life without happiness is no life at all.
Hello Markmac
If you are only after the rear block it does not matter, But from a resale point
you would probley be better with the 1913 set. Is it possible to lower the front sight?
It will do the same thing.....
Regards Adrian
Thanks Adrian.
No it is not possible to lower the foresight,unfortunately - So I will buy the Riser Block for the 1913
Thanks again
Life without happiness is no life at all.