Personally use 1 piece mounts or can you use the mount locator pin thingy?
trying to set up my scope on my hw80, getting it all lined up and noticed the scope is sliding back in the mounts, mounts aren't moving just the scope. mounts are tightened.
doing my head in now, thinking of selling and just shooting my pcp's.
the 80 has a vmach kit fitted, but the kick back is making the scope move.
anything that can be done to stop it?
cheers all
Personally use 1 piece mounts or can you use the mount locator pin thingy?
Fairly obviously the clamp is not tight enough to hold the scope securly, either give the bolts a tweek or line the clamp with tape to provide more grip.
or if the clamp is secure to the rifle position the scope so that either a turret or the objective bell butt up against the clamp.
Dampa mount.
Get a better/new set of mounts, this shouldn't be happening. As mentioned; try some tape or something to shim up the mounts. If the mounts are fully closed up then the tube must be crushed unless the mounts are cr@p, they shouldn't be fully closed.
If the scope tube was crushed in at the mount points then the scope wouldn't move back.
If you have tightened them up as tight as they will go and it isn't crimping the tube on the scope then you simply need different mounts.
My 1 inch mounts on my Pro Air scopes still have a gap either side.
Take your scope into a decent shop and try some mounts that will hold it tight without the clamps touching.
How about some strips of cycle tyre innertube between the scope and mounts??
P.S Not a great advert for Vmach
This might be a stupid suggestion, but you're not using 30mm mounts on a 25mm scope?